After this lesson
- Insert all four middle-layer edges
- Choose the correct left or right insertion
- Recover an edge stuck in the wrong slot
Find and align
Flip the cube so the completed white layer is on the bottom. Find an edge in the top layer that does not contain yellow. Match its front colour to the front centre. The other colour tells you whether the edge belongs to the right or left slot.
Right and left insertions
If the edge's second colour matches the right centre, insert it to the right. If it matches the left centre, insert it to the left. The two algorithms are mirrors; learn one and you effectively know both.
U R U' R' U' F' U F
Insert into the right-hand middle slot.
U' L' U L U F U' F'
Insert into the left-hand middle slot.
The trapped edge
Sometimes an edge is already in the middle layer but in the wrong slot, or flipped. You cannot pull it out directly with the insertion algorithm. Instead, insert any incorrect top-layer edge into that slot; this ejects the trapped edge into the top layer, where it can be solved normally.
This is a general cube principle: to move a piece out of a slot, put another piece into the slot first.
Keep the first layer on the bottom while you turn the top layer to find edges. A quick tilt of the cube is enough to inspect the side colours.
Check your understanding
1. Which colour should a middle-layer edge never contain?
2. How do you remove an edge trapped in the wrong middle slot?
3. How many middle-layer edges are there?