Last layer edges — Z. Hold with the two edges to swap at front-right. Pull the middle slice back. Flip twice, move the top left, flip twice, move left, flip twice, move left. Pull the middle slice back, move the top right twice, flip twice — two pairs of adjacent edges swap diagonally.
Drag a face to turn · drag background to orbit
Tip: use Play then Step to walk through the algorithm move by move. Reset returns to the inverse setup state.
Last layer edges — Z is used in the two-look beginner method. Match the top-layer pattern before executing the algorithm.
This is a two-look beginner algorithm. It deliberately uses a small set of triggers so the case can be solved without learning a large recognition system.
Load the case, hide the algorithm, and execute it from memory. Then use Reset to repeat the same state. Vary the AUF after each success so recognition does not depend on one angle.
M' U' (M2 U') (M2 U') M' U2 M2. The library lists 1 algorithm for this case; the primary is 9 moves.
Last layer edges — Z is used in the two-look beginner method. Match the top-layer pattern before executing the algorithm.
No claim of optimality is made. These are community-standard speedcubing algorithms, selected for ergonomics and recognition. The Kociemba solver in this project can produce short solutions for a whole cube, but those solutions are not guaranteed to be optimal either.
Yes. The algorithm was parsed by the project engine and passed this set's structural checks. Source: andyjudson/cfop (MIT).